Driver fatigue monitor with signal output 45km/h start-up speed
Description
Fatigue and microsleep at the wheel are often the cause of serious
accidents. However, the initial signs of fatigue can be detected
before a critical situation arises. The driver drowsiness detection
can do this by monitoring steering movements and advising drivers
to take a break in time.
I/O and RS232 output optional:
I/O output is only a high/low voltage output, you can get only the
alarm signal,the connection is easy. The default setting is high
resistance status under normal status, low voltage output when
triggered.
RS232 output has alarm signal and picture output, thus you can get
the driver's face picture in the center, it need to integrate to
the GPS system via protocol.
Attention:
Non-authorized person, please do not open or repair the device.
Please do not operate the system when driving to avoid dangerous
Please handle carefully, do not drop or impact with hard objectives
Do not use chemicals or cleaning agents to clean the machine, it
will damage the machine surfaces or rust the paint.
keep it away from water or moist place, device will be rusted or
shortcut in those area.
Do not rip, bend or squeezed the wiring by heavy object, or it will
be hot to fire.
Power input and output
| Input | 9-36V |
| power consumption | 100mA in 12V car, and 60mA in 24V car |
| I/O output | high resistance status under normal status, low voltage output when
triggered |
| Working Temprature: | 0-80℃ |
| Working Humility: | 10%-90% |
| Weigh: | 108g |
| Demension: | 4.5*10.2cm |
1. Input: 9-36V, LS803 is suitable for both 12V and 24V vehicle,
and have good high voltage protection.
2. very lower power consumption, average current less then 100mA in
12V car, and 60mA in 24V car, similar with leakage from the
battery, almost does not consume battery power.
3. I/O output, high resistance status under normal status, low
voltage output when triggered.
4. Working Temprature: 0-80℃
5. Working Humility: 10%-90%
6. Weigh:108g
7. Demension: 4.5*10.2cm
